Horizon Stevedoring, Inc.

An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.

An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.

An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.

An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.

An employee was pushing a container when they were struck by a forklift. The employee sustained a left leg fracture.

While preparing to install a new spool piece for a vapor and spent sulfuric acid line, an employee was working to ensure there was no residual product or pressure in the line before removing the 6-inch hose. The valve was cracked, and some spent acid still in the line sprayed out. The employee was standing off to the side and at a distance, but was still contacted by the hot acid, resulting in corrosive and thermal burns to their upper torso and mid-thighs of both legs.

An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.

The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.

An employee was standing on the outside edge of a hopper barge while watching a skid steer push ore for an excavator (with a clamshell bucket) to unload. The excavator was on a work barge. The bucket of the excavator struck the employee and caused a near-amputation of their right arm and fractures of the ulna and radius of the left arm. The right arm required surgery.

An employee was inspecting a conveyor to see why it was not running. The employee entered the the conveyor motor area, tripped on a piece of angle iron welded to the floor, and fell. The employee sustained a fractured orbital bone.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.