Port Inn

An employee was walking to their truck to look for a lid. When they stepped between the truck and a dock plate, they sustained a knee injury that required surgery.

An employee was standing on plant bed timbers, using a powered hand trimmer to trim the shrubs in the plant bed. The timber gave way, breaking into several pieces. The employee lost balance and fell with the trimmer in his hand. He suffered a severe laceration to the right wrist and hand.

A mail carrier slipped on ice and sustained a strain that required hospitalization.

An employee was loading phosphoric acid onto a rail car and preparing to secure the rail car for transport. While repositioning the loadout spout to secure it back to the drip pan holster on the dock, the spout contacted the handrail of the rail car, causing the employee to lose balance. The employee stepped back and their right foot entered the opening for the rail car, causing him to twist/pivot on his left leg. The employee's lower left leg was fractured.

On November 14, 2023, an employee was receiving a delivery from a truck when some of the merchandise fell from the truck s lift and struck him. He then fell to the ground and his head struck the sidewalk, resulting in an injury that required hospitalization.

An employee was checking credentials for vehicles entering an area. While approaching a vehicle that had failed to stop as instructed, the employee lost his balance and fell backward, landing on his back. The car struck him, and he suffered a tailbone fracture and a kidney injury.

An employee was removing rigging from a post-tensioning strand when it suddenly whipped and unwound. The employee suffered an avulsion to the right thumb.

An employee was entering a doorway on the seventeenth floor of an enclosed building when the door closed on his left index finger, crushing it. The fingertip was amputated.

An employee was exiting a train. The employee's foot was caught, and the employee fell, suffering a broken left arm.

A restroom stall door swung open, bounced back at the employee, and the coat hook on the door impaled his left eye. He was hospitalized, requiring surgery.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.