Rite Aid

An employee tripped and fell, suffered a broken left hip, and was hospitalized.

An employee tripped on a plastic tote behind a register, fell to the floor, and suffered a broken left hip. The employee was hospitalized.

An employee was reaching for an item on an upper shelf when she fell to the ground, resulting in a leg fracture and head laceration.

While walking across the parking lot, an employee slipped on snow/ice and fell on the ground, fracturing their right hip.

An employee was operating a walkie-rider. The walkie-rider would not stop and the employee's foot was crushed between the walkie-rider and a guard on a conveyor.

An employee was stepping down from the tailgate of a customer's pickup truck. The truck then backed up and struck the employee, then pulled forward, striking them again while they were underneath the truck. The employee sustained fractures to their L3 vertebra, ribs, and a leg.

An employee was in front of a skid loader that was hauling a tree to be planted. The employee was holding the tree so it wouldn't fall over when his leg and foot were run over by the skid loader and fractured.

An employee was walking through the parking lot, returning from their break, when a motor vehicle struck them. The employee sustained a concussion, facial fracture, and contusions.

An employee was walking up to a powered industrial vehicle (PIV) to grab a water bottle. As the vehicle was turning, the employee was struck by the PIV and sustained a spleen laceration and injury to the left arm and chest. The employee was hospitalized.

While standing on the curb in front of the store, an employee was struck by a car. The car was then put in reverse and ran over the employee again. The employee sustained fractures to their ribs and both legs.

An employee was working at a register when she tripped on a scanner cord and fell, resulting in hospitalization for a hip fracture.

An employee was loading cardboard into a cardboard bailer to be compressed. The machine began to operate with the door open, and the employee's left hand was fractured.

An employee was walking to their car after work. They tripped over a concrete parking stop and fell in the parking lot. The employee was hospitalized with a concussion.

An employee was putting a box onto a cart when a handle on the box broke and the cart began to roll away from her. She lost her balance, fell with the box still in her hands, and broke her left hip. She was hospitalized.

An employee was using a photo cutting trimmer board to trim photos and amputated their left thumb tip without bone loss.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.