Timber Technologies, LLC

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee became overheated while working at a plywood production facility. The employee sustained dehydration, heat syncope, rhabdomyolysis, and an acute kidney injury.

An employee was standing on a platform, cleaning a mold, when he fell through an opening in the platform to the concrete floor approximately 6 feet below. The employee was hospitalized with injuries to his shoulder, elbow, and rib.

The injured employee was on the ground level receiving an OSB board from a co-worker who was on a 10-foot-high catwalk. The board was 4 feet by 25 feet and weighed approximately 270 pounds. As it was being slid down a handrail by a crew of three employees, the board went over the rail and landed on the injured employee's left foot, resulting in a fracture.

An employee was unloading wood trusses from a trailer when a few trusses fell and struck him. The employee sustained a hip fracture.

An employee was working on a wood lamination machine to form arches. As the employee was using a hammer, it struck his thumb, resulting in a fingertip amputation.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.