Direct exposure to electricity, 220 volts or less · Second degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at Emerson Power and Water Solutions Inc, 296 Poplar Neck Road, BIRDSBORO, PENNSYLVANIA 19508
on — Second degree electrical burns, affecting the hand(s), unspecified.
Final narrative
An employee was performing work in a 24-volt DC electrical cabinet. While working, a loose wire grounded out and arced; the employee received an electrical shock and his left hand sustained a second degree burn.
An employee was setting up music for a fitness class. As the employee plugged their personal device into the outlet, she was shocked. The employee experienced pain in her left side, mainly in her arm and head.
Two employees were testing the phase voltage of the 208 volt bus bar circuit. An arc flash occurred during the testing. One employee suffered burns to the face, neck, and hands. Another employee suffered burns to his arm.
An employee was working to free a load by grabbing and shaking the live side of a tugger line. Once the load became free and progressed upward, the employee's hand was caught and pulled into a snatch block. The employee's right thumb was broken and lacerated. The employee was hospitalized and required a surgical amputation.
An employee was operating a drill rig when when their hand got caught between a 1/4-inch steel cable and a drill rod, resulting in the amputation of four fingers.
An employee was overseeing the operation of a rope being respooled onto the drum of a wire winding machine. He went to remove a piece of wooden reel from the rope. His glove got snagged and his right hand was pulled into the roller, pinching his fingers between the machine's roller and the rope. The middle and index fingers were crushed.
An employee was visiting a patient's home to fit them with a wearable cardiac defibrillator. As he was walking from the front door to his car, a large dog broke free from a chain and attacked him. He was bitten on the forearm and fell. The patient was then able to restrain the dog. The employee was hospitalized with severe dog bites and required surgery.
An employee tripped over a junior I-beam about 4 feet long and 6 inches tall that was installed for circulating water valves and fell to the ground, resulting in a broken right-side rib.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.