MILWAUKEE, WISCONSIN—
Pak-Rite, Ltd.
Struck by rolling object or equipment-other than powered vehicle, n.e.c. · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury at Pak-Rite, Ltd., 2395 South Burrell Street, MILWAUKEE, WISCONSIN 53207 on — Soreness, pain, hurt-nonspecified injury, affecting the leg(s), unspecified.
Final narrative
An employee was unloading a trainer (similar in appearance to a tool box on wheels) from a crate to prepare the crate for repair. As the trainer was being rolled down the built-in ramp using a winch, it started to tip off of the side. The employee attempted to prevent the trainer from falling on its side, resulting in the trainer striking the employee's leg. The employee was hospitalized.
Similar incidents · Same event type
ALLEN, TEXAS—
Cabela's
An employee was pushing carts into the chute area for customers to retrieve. The first of six carts struck the wall and caused the other carts to bounce back and strike the employee. The carts knocked the employee to the ground and she sustained a back injury.
DICKINSON, TEXAS—
RedGuard LLC
An employee was loading a portable storage container onto a dovetail trailer. This requires hooking up a bridle to the container and lifting the container enough for the dovetail to begin to slide under it. The employee reached and held the bridle lock to allow the trailer to move under it when the trailer moved backward instead of forward and caught his finger. The employee's right middle finger was amputated between the fingernail and the first knuckle.
HOUSTON, TEXAS—
Gulf Stream Marine
An employee was reaching over a small stack of steel billets on the ground to cut a strap. When the strap was cut, one of the billets (weighing 5,182 pounds) rolled down onto his right leg. He was pinned and suffered a broken tibia. The incident occurred while the employee was training.
BATH, SOUTH DAKOTA—
Northern Electric Cooperative
On June 7, 2023, employees were unloading a box truck and rolling a reel of 2-inch plastic pipe to the back of the truck. As the employees were rolling the reel, the edge of the steel frame of the reel contacted the side of the truck. The injured employee s right little finger was caught between the reel and the truck, resulting in a laceration and fracture as well as a little finger amputation.
BROOKLYN, NEW YORK—
WDF, Inc.
Employees were using a dolly to remove a trash compactor unit from a residential home. As they began to transport it out of the room and to the outside, the dolly encountered uneven ground. This caused the dolly and the unit to move quicker than expected. The injured employee's left hand was then caught between a nearby concrete column and the compactor unit, resulting in fractures of the left ring and middle fingers that required amputation.
More severe injuries in this industry (NAICS 321920)
AUSTIN, TEXAS—
Pallet Bros. ATX, LLC
An employee was cutting wood with a miter saw when their clothing was pulled into the blade, resulting in a bicep laceration. The employee was hospitalized. The blade cover was not in place at the time of the incident.
SAINT ALBANS, MAINE—
GERRITY INDUSTRIES
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
GUTHRIE, OKLAHOMA—
Burgess Manufacturing of Oklahoma Inc.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.
COLUMBUS, OHIO—
Kamps, Inc
An employee was operating a bubble wrap production line. He was splicing the ends of the film rolls together with tape when a driven roll contacted his hand. His hand and arm were pulled into the machine up to his shoulder. The employee's forearm contacted the the hot surface (230-500 F) of the bubble stamping cylinder. He was hospitalized with burns to the forearm that required surgery and crushing injuries to the hand and forearm without fractures.
YOUNGSTOWN, OHIO—
Iron City Wood Products, Inc.
An employee was operating a pallet dismantling saw. A board became stuck, and the employee tried to pull the pallet. When the board broke, the employee's right hand made contact with the blade, resulting in the amputation of the right middle finger above the second knuckle.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.