Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Unilin North America, 22 Mine Road, HOLDEN, WEST VIRGINIA 25625
on — Amputations, affecting the fingertip(s).
Final narrative
An employee went to grab a board before it slid down the chute at the output side of the re-rip saw. He contacted the flat chain that was moving, and his right ring fingertip was cut off. There was no bone loss or nail loss.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was adjusting the height of an ultraviolet (UV) lamp. She was electrocuted by the UV machine. She sustained burns on her left hand and an entry wound on the right forearm. The employee was hospitalized.
On August 14, 2025, an employee was rebuilding a tile-cutting die when their right wrist contacted the cutting blade, resulting in a laceration that required hospitalization.
An employee was removing a jammed piece of scrap wood from the end of a machine saw when the wood pulled their right hand into the saw blade, resulting in an index finger amputation below the second knuckle.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.