Caught in or compressed by equipment or objects, n.e.c. · Internal injuries to organs and blood vessels of the trunk
At a glance
Federal OSHA recorded a severe workplace injury
at Greenway Equipment, Inc., 936 Hwy 64 W, MARION, ARKANSAS 72364
on — Internal injuries to organs and blood vessels of the trunk, affecting the multiple trunk locations.
Watch Greenway Equipment, Inc. — freeGet an email when a new federal OSHA severe-injury report for Greenway Equipment, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was crushed between two tractors. Employees were using jumper cables to boost a dead battery on a John Deere agriculture tractor when the tractor jumped backwards and the employee became pinned between the weights on the front of the back tractor and the back wheel of the front tractor. The injured employee had internal bleeding, sustained a collapsed lung and a tear in his small intestines.
An employee was offloading containers from his truck using a deck that goes up and down. When the deck was up, he took a step and his foot went between the truck and the deck, resulting in a foot/ankle fracture.
An employee was using a hoist to lift large containers (420 pounds) of steel parts to be dipped into tanks. The employee set a container down on a support and his finger was caught between the container and the support, resulting in amputation just behind the first knuckle.
An employee was operating a riding mower. The employee's left hand became stuck between the mower's front left support bar and its reel. The employee suffered tendon damage to the middle three fingers.
An employee was guiding a motor into a container while a forklift was lowering it. The employee made contact with the motor, which amputated the top of his left thumb.
An employee was moving 4-inch square tubing from a pallet to a four-post rack when his right ring finger was caught between the end of a tube and the rack. The employee's finger was partially amputated.
More severe injuries in this industry (NAICS 423820)
During a break, an employee was engaged in a conversation with a customer. They were standing approximately 7 feet in front of a combine header that was attached to a payloader but also set on jack stands for support. The header dislodged from the payloader, slid forward along with its support stand, and struck both the employee and the customer. The employee was hospitalized with fractures to thoracic and lumbar vertebrae, a fractured rib, and a partially deflated lung. The customer also sustained injury.
An employee was replacing a manure belt in an egg producing poultry house. He was using a mechanical roller and a steel cable to pull (remove) the old manure belt. The employee's ring and little fingertips were pinched between the roller and the cable resulting in partial amputations above the top knuckle.
An employee was walking past a cow barn when he slipped on a wet floor mat and fell. The employee sustained torn ligaments and his quadriceps were torn from the bone on both legs.
An employee was working on a bale accumulator attached to a tractor. While he was making adjustments, the accumulator activated. The bar of the accumulator struck him and dragged him to the side, and his right leg was run over. He suffered a broken femur.
An employee tripped on a piece of wood and fell onto the rough edge of a metal tank under fabrication. The employee was hospitalized with a laceration on his hand.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.