Advanced Disposal Columbus Hauling

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

On September 30, 2025, at 1:45 a.m., an employee was operating a forklift to load materials on an outbound dock. His left foot became caught between the forklift and a pole, resulting in a broken big toe.

An employee was riding a horse in the horse corral/riding arena when the horse bucked multiple times. The employee performed an emergency dismount off the right side of the horse. When she landed, she fell backward in the sand, onto her back. The employee sustained a crushed vertebra.

An employee was pulling an electrical wire from a circuit. The wire contacted a live wire and created an arc flash. The employee sustained burns on their left side and arm.

An employee was operating a heat press machine. His right foot was caught between a paper roller and the heat press, resulting in amputation of a toe.

On 11/08/2024, an employee was working on piping a refrigeration condenser. Refrigeration condensers arrive from the factory with the internal piping pressurized and the end capped. The employee was cutting a capped refrigeration line when the cap blew off, striking the battery-operated saw he was using and knocking the saw it into his face. He was cut under the nose and struck on the head. The angle of the impact pushed metal fragments under his safety glasses and into his eyes. The employee sustained metal fragments in his eyes, lacerations to the face, and contusions to the head.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.