First Energy

Two employees were transporting a transformer from a tow boat to the plant using a forklift. The parking break failed and the vehicle rolled over the employee's ankle, resulting in a fracture and hospitalization.

An employee was removing an old meter face. When he attempted to restore power an arc flash occurred. He was electrocuted and required hospitalization.

An employee was working on a vice that was not cranking down, so the employee tried to push down on the side of the vice. The vice let loose and the employee's right pinky was crushed between the anvil side and the mechanical side of the vice. The employee eventually required a medical amputation of the fingertip.

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

Employees were preparing to replace a primary electrical cable. While two of the employees were working to remove the cable on one side of a switchgear, they came into contact with a wrench and the outside part of the switchgear. One employee suffered an electrical shock.

An employee was walking to her work truck when she tripped over a safety cone and fell to the asphalt, resulting in a fractured tibia.

An employee was installing personal protective grounds at a substation when their hand contacted the end of the ground that was not energized, but induced voltage was created by wind and shocked them. This resulted in a burn on their thumb.

At about 9:35 a.m. on March 18, 2024, an employee was conducting maintenance on a non-operational fan controller in a switchgear room. The employee pulled the controller and began installing a new one. The employee was electrocuted, suffering third-degree burns to the right hand and fingers as well as burns to the right forearm, and was hospitalized.

An employee was working outside, sustained a heat-related illness, and was hospitalized.

An employee was working to deliver mail to an apartment building. She was waiting for a customer to move, to obtain clearance to the mailboxes. The door swung inward and closed on her right little finger. The top half of her finger was surgically amputated.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

On October 30, 2025, an employee was working to adjust a stackable metal shipping container. As the container dropped into place, it caught the employee's hands in an area between the upper and lower cross-members. The employee suffered a laceration to the left ring finger that required stitches, bruising to the right ring finger, and fractures to the right middle finger that necessitated medical amputation of the fingertip.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.