Compressed or pinched by shifting objects or equipment · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at Halliburton Energy Services, Inc., 1109 Foundation Drive, CALDWELL, TEXAS 77836
on — Bruises, contusions, affecting the arm(s), unspecified.
Final narrative
An employee was performing a fluid end replacement on a pump using an impact gun to remove pump suction manifold bolts. While loosening the bolts, the suction manifold fell ~6 inches catching employee's arms between the suction manifold and trail fender resulting in a contusion injury. The header weighs approximately 250-300 pounds.
HospitalizedArm(s), unspecifiedPumps
More severe injuries at Halliburton Energy Services, Inc.
An employee was on the floor of a workover rig to install an electric submersible pump when rig blocks fell and struck them, resulting in seven broken ribs and a lacerated finger.
An employee was removing a clamp from the electrical submersible pump string of a laydown machine when their left index finger was caught between the clamp and the machine. The employee sustained a partial amputation between the first knuckle and the fingernail.
An employee was unlatching a sand container from a trailer so a forklift operator could then remove the container. While the employee was unlatching the container, the forklift operator pulled toward the container to remove it. The employee was struck in the abdominal area by a fork on the forklift, resulting in an abdominal injury.
An employee was removing a rubber core using a manually operated core puller when their left index finger was pinched by a pin and a piece of the tooling equipment. The employee's left index fingertip was medically amputated.
Two employees were performing maintenance on a horse power unit. The plunger was pushed back in and an employee's left index and middle fingers were caught between the fluid-end plunger and power-end plunger, resulting in a laceration and amputation.
An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.
An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.
An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.
During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.
An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.
More severe injuries in this industry (NAICS 213112)
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.
An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.