Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Kelly Lindsey, P.O. Box 134, WESLEY, ARKANSAS 72773
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was cutting plastic laminate when the laminate moved and pulled his hand toward the saw. His index, middle, and ring fingers were partially amputated.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee fell to an office floor, landing on her right side and suffering a broken hip, a broken right arm, and a concussion. She was hospitalized, requiring surgery.
An employee was clearing a small piece of wood that had jammed in the back of a machine. A cutting blade in the machine lacerated the employee's right forearm. The employee was hospitalized, requiring surgery.
An employee was operating a stand-up forklift to travel from the warehouse to the breakroom area. The forklift struck the breakroom wall, causing a fracture/crush injury to his left foot.
An employee was cutting a piece of wood with a table saw. The wood bound in the saw, which then pulled the employee's right hand into the blade. His middle finger was cut and fractured.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.