Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Williamsport Steel Container Corp., 360 ARCH STREET, WILLIAMSPORT, PENNSYLVANIA 17701
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Watch Williamsport Steel Container Corp. — freeGet an email when a new federal OSHA severe-injury report for Williamsport Steel Container Corp. is published. One employer, no account, unsubscribe in one click.
Final narrative
While attempting to clear a jam on the pre-curl machine, an employee's right finger was amputated to the knuckle by the machine's teeth.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332439)
An employee was preparing to remove the drive chain of a conveyor motor. Their thumb became caught in the sprocket and chain of the drive motor, resulting in an amputation to the thumb tip between the nail and the first joint.
An employee was working with a drill press when his glove and forearm were caught by the drill bit, resulting in lacerations and fractures to his right forearm. The employee's arm was amputated below the elbow.
An employee was walking on a sidewalk when he stepped off the sidewalk into the grass. As he was stepping onto the concrete parking lot, he tripped over the edge of the concrete and fell onto his left hip. The employee was hospitalized.
An employee was changing the cooling nozzles on an aftercooler and the pneumatic power was activated. This caused the top plate to move into the top position and crush the employee's right arm. The employee sustained a fractured arm.
On October 15, 2024, an employee was cleaning a drum welder with a rag. The machine pulled in the rag and injured three fingers on the employee's left hand. The employee was hospitalized with three partially amputated fingers.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.