Beckett Family Services

An employee was walking down the hallway when they tripped and fell to the floor, fracturing their right wrist.

An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.

An employee was carrying furniture backward during a delivery when he tripped and broke his right ankle.

An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.

An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.

An employee was walking on the sidewalk when they slipped on ice and fell to the ground. The employee sustained fractures to their knee and ankle.

An employee was using a table saw to cut a 1-inch x 1-inch board down to 1/2-inch to make repairs to a closet in an apartment unit. While cutting/feeding the wood through the saw, the edge of his right middle finger caught on the saw blade, resulting in an amputation.

An employee was walking to their work vehicle in the parking lot when they slipped on ice and struck the ground. The employee was hospitalized with a back fracture and required surgery.

An employee was checking the air conditioning while standing on a chair when they fell to the floor and sustained a fracture to their hip joint.

An employee was stuck by a push cart while walking around a corner. She fell to the ground and suffered a broken hip. She was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.