105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Alabama Power Company

Compressed or pinched by shifting objects or equipment · Open wounds, n.e.c.

Federal OSHA recorded a severe workplace injury at Alabama Power Company, 15300 HWY 43 N., BUCKS, ALABAMA 36512 on — Open wounds, n.e.c., affecting the finger(s), fingernail(s), unspecified.

An employee was relocating a tool cart. While backing it down a ramp, he caught his finger between the cart and a steel column causing an open fracture to his right middle finger.

Hospitalized Finger(s), fingernail(s), unspecified Cart, dolly, hand truck-nonpowered

Alabama Power Company

Employees were pulling three-phase power lines to a power pole. An employee's hand was caught between a pulley and a rope, resulting in amputation of the employee's index, middle, and ring fingertips.

Alabama Power Company

Three employees were preparing to unload a burnt pole from the back of their work truck. The injured employee was standing on the driver's side step of the truck while another employee in the rear of the truck began deploying the outriggers. The injured employee stepped down from the truck underneath the outriggers, resulting in multiple fractures and a partial amputation to her right big toe.

Alabama Power Company

An employee was performing maintenance on a pump for a sulfuric acid system. Some of the acid sprayed out of a leak and burned the employee's face, neck, and head.

Alabama Power Company

An employee was operating a golf cart to cross an empty parking lot when the vehicle struck a utility pole that was extending from behind a truck. The employee sustained facial fractures.

Alabama Power Company

An employee was descending a wooden power pole. He slipped and fell about 4 feet; his right gaff caught the pole and stopped him suddenly, causing his right knee to be dislocated.

View Alabama Power Company's full OSHA safety record →

TForce Freight

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

Liveo Research, Inc.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

Best Pump and Flow

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

FORD MOTOR COMPANY

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

Lasseter Tractor Company. Inc.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

Tampa Electric Company

Employees were preparing to replace a primary electrical cable. While two of the employees were working to remove the cable on one side of a switchgear, they came into contact with a wrench and the outside part of the switchgear. One employee suffered an electrical shock.

El Paso Electric Company

An employee was walking to her work truck when she tripped over a safety cone and fell to the asphalt, resulting in a fractured tibia.

Florida Power & Light Company

An employee was installing personal protective grounds at a substation when their hand contacted the end of the ground that was not energized, but induced voltage was created by wind and shocked them. This resulted in a burn on their thumb.

Entergy

At about 9:35 a.m. on March 18, 2024, an employee was conducting maintenance on a non-operational fan controller in a switchgear room. The employee pulled the controller and began installing a new one. The employee was electrocuted, suffering third-degree burns to the right hand and fingers as well as burns to the right forearm, and was hospitalized.

Tampa Electric Company

An employee was working outside, sustained a heat-related illness, and was hospitalized.

Sysco Gulf Coast, LLC

An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.

Norflex, Inc.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

Ampler Pizza II LLC

An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.

Birdsong Corporation

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

Pilgrims

An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.