Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Tab Products CO LLC, 605 Fourth Street, MAYVILLE, WISCONSIN 53050
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was working on a folder line. The folder line has two rotating cylinders that apply a stamp. The employee's right hand was caught between two running cylinders resulting in the amputation of the middle, ring and pinky fingertips.
AmputationFingertip(s)Paper production machinery, n.e.c.
On September 28, 2021, at approximately 5:30 a.m., an employee separated two paper rolls and began feeding the first paper roll into a die cutting press used to fabricate file folders. Each roll weighs approximately 900 pounds. The second roll tipped over and struck the employee's left leg, resulting in a fractured femur.
An employee was putting glue into a AAA glue machine. The machine was running at the time. The cap fell off and fell into the machine. The employee reached into the machine to retrieve the cap and amputated his right hand middle finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 322231)
An employee was removing a paper jam from an F-27 File Folder Single Lane Machine while operating it in jog mode. His left ring and middle fingers were caught in a roller, resulting in the loss of the fingertip pad on the ring finger.
An employee was putting glue into a AAA glue machine. The machine was running at the time. The cap fell off and fell into the machine. The employee reached into the machine to retrieve the cap and amputated his right hand middle finger.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.