A & W SHEET METAL, INC.

An employee was getting a tool bag that was on a second-story roof when they fell from the roof to the ground. The employee was hospitalized with injuries to their rib cage and lower back.

An employee was installing a clip on the roof when they slipped and fell approximately 25 feet to the ground below, resulting in a broken hip, broken leg, and bleeding in the brain.

An employee was setting up the worksite for the day. While moving an extension cord, he fell backward off the roof of the two-story building and sustained a broken pelvis.

An employee was going up in a lift to begin trimming trees with a chainsaw. He was approximately 20-25 feet in the air when the latch to the bucket got caught and detached. The bucket then tipped causing the employee to fall to the ground. He sustained fractures to his right elbow, right wrist, and left femur.

An employee was laying down felt paper on a new residential property when they fell approximately 21 feet to the ground. The employee sustained fractures of the L2 vertebra, right tibia, and left wrist as well as a left heel dislocation. The employee was wearing fall protection at the time.

An employee was pulling a data cable through a ceiling. He fell through the ceiling, landing at ground level. He suffered a laceration to the forehead, a dislocated left little finger, a broken left ring finger, and a laceration to the liver.

On September 16, 2025, an employee was installing and adjusting spotlights on a performance stage that was under construction. While crossing the stage to speak with other contractors, the employee encountered a section of the stage where the elevation changed to a lower level. As the employee stepped down 14 inches to the lower level, his knee locked up and he fell to the stage. He subsequently rolled off the stage and fell approximately 2 to 3 feet to the floor, resulting in a fractured tibial plateau in his right leg.

An employee was delivering a 65-foot boom lift to a rental customer's construction site. The employee set up the ramp truck in the parking lot adjacent to the construction site. He elevated the boom 4-5 feet to clear a temporary fence. While driving the boom lift off the ramp, the wheels slid to the driver's side of the ramp truck, ultimately sliding off the ramp. The boom lift fell off the side of the truck and rolled onto its side. The employee sustained a fractured clavicle, a dislocated shoulder, separated/fractured ribs, a punctured lung, and a fractured left femur. The employee required surgery.

An employee was performing maintenance on a telehandler and installing a carriage lift cylinder. The employee was checking the alignment when the cylinder slipped and partially amputated his left middle finger.

An employee had just serviced a battery and was reinstalling it in a forklift using a battery extractor. The employee was trying to pull the battery out of the battery compartment when the extractor moved, causing the battery to shift on the rollers. The employee's right hand was crushed between the top of the battery and the battery compartment.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.