Berenfield Containers Ltd

On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.

An employee was examining a machine when a part moved up and amputated a fingertip on their left hand.

An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.

An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.

An employee's right hand was caught in a wire drawing machine, resulting in amputation.

An employee was preparing to remove the drive chain of a conveyor motor. Their thumb became caught in the sprocket and chain of the drive motor, resulting in an amputation to the thumb tip between the nail and the first joint.

An employee was working with a drill press when his glove and forearm were caught by the drill bit, resulting in lacerations and fractures to his right forearm. The employee's arm was amputated below the elbow.

An employee was walking on a sidewalk when he stepped off the sidewalk into the grass. As he was stepping onto the concrete parking lot, he tripped over the edge of the concrete and fell onto his left hip. The employee was hospitalized.

An employee was changing the cooling nozzles on an aftercooler and the pneumatic power was activated. This caused the top plate to move into the top position and crush the employee's right arm. The employee sustained a fractured arm.

On October 15, 2024, an employee was cleaning a drum welder with a rag. The machine pulled in the rag and injured three fingers on the employee's left hand. The employee was hospitalized with three partially amputated fingers.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.