EXPERT RISER SOLUTIONS

On November 9, 2023, an employee was removing plywood from the west face of a basement level buck hoist to prepare to dismantle one of the cabs. When the employee pulled on the plywood, it fell and pulled a rope that partially amputated the employee's thumb.

An employee was holding a rigging line and assisting in the removal of an old light pole from its base. When the load was lifted by a forklift, it shifted. The tag line lifted the employee off the ground and propelled him through the air. The employee landed on the ground and sustained back fractures.

An employee was performing maintenance on a bucket truck when his right hand became caught in some rope, causing amputations to three fingers down to the first knuckle.

An employee was conducting a fall rescue demonstration. A 165-pound demonstration dummy was released from a height, putting tension on the lanyard. The employee's left hand, little finger, and thumb were caught in the wire rope lanyard, resulting in a medical amputation of the left little finger as well as lacerations to the left thumb.

An employee was using a crank and cable to lower a light tower due to windy conditions. The light shaft became hung up and released the tension in the cable, which wrapped around the employee's left hand, resulting in amputations of three fingers.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.

An employee was assisting the crew with patching and restoring a roadway after the installation of a sewer line. He was helping place and level the blacktop/backfill material over the trench area to bring the road surface back to proper grade. The employee was walking between a forward-moving dump truck and a dirt pile when his right foot was run over by the truck s wheel, causing him to fall. The employee sustained injury to his foot.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was operating a skid steer with a bucket attachment at a demolition site. While driving it to the rear of the property to park it, the employee came into contact with a live electrical transformer unit that was located outside of the facility. The employee sustained electrical burns on his hands extending up to his elbows and a fractured ankle.

An employee was installing a door on a semi-trailer. They were using a forklift to lift the door to the height of the trailer when the door became jammed between the forklift mast and the hinge on the trailer. When the employee went to dislodge the door from the mast, the door fell and crushed their foot. Their big toe was amputated. The employee was hospitalized and their big toe was surgically reattached. The employee's foot and other toes also required surgery.

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.

A security employee was holstering her firearm when the gun discharged a bullet into her right leg. The employee was hospitalized.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.