ROBERT BOSCH TOOL CORPORATION

An employee was on a double-end rider in an aisle selecting product when his left leg was pinned between the rack and rider.

An employee was using a forklift to load a tractor trailer when the forklift skidded into a wall. The employee sustained an arm fracture.

An employee was training on an rolling container carrier on the dry, non-frozen storage side of the distribution center. She made a turn around the end cap and her right foot struck the rail protecting the endcap racking. The employee's foot was fractured.

An employee was a passenger in a utility vehicle that was driving up a hill on a wooded trail. As the vehicle made a right turn, three fingers on the employee's right hand were caught against a tree and fractured.

An employee was operating a forklift when his left leg was caught between the forklift and a bollard resulting in a broken leg.

An employee was backing up an electric pallet jack when it struck a yellow guardrail, pinning his ankle between the pallet jack and the guardrail. The employee suffered a crush injury to his left ankle and shin.

The injured employee was going to use an elevator to go upstairs. The elevator does not have a call button and is operated manually. The employee approached the elevator and used the elevator drop key located in the elevator key box to manually open the door. He then stepped forward into the elevator shaft. The elevator car was on another floor, resulting in the employee falling down the shaft from the first floor to the basement level. The employee was hospitalized with a sprained left hand and bilateral calcaneal fractures.

An employee was aligning a shipping offload conveyor. A component of the machine caught the employee's left middle finger, amputating it above the second knuckle.

An employee was using a torch to burn off liquid petroleum gas from old 100-pound cylinders so they could be recycled. When he went to move a tank, some gas spilled onto the ground, then ignited in a flash that engulfed him. He was burned on the face, hands, and back and was hospitalized.

An employee was escorting a forklift inside a store. While walking backward, the employee tripped on a pallet and fell, suffering a broken hip.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.