Pedestrian struck by forward-moving vehicle in work zone · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Oxford Construction, Inc., Hwy. 82, CUTHBERT, GEORGIA 39840
on — Fractures, affecting the multiple body parts, n.e.c..
Final narrative
An employee was stopping traffic as a flagger. A truck failed to slow down or stop, crashing and skidding off a stopped car. The employee saw the collision coming, attempted to run to safety, and was struck by the truck, suffering a broken hip and shoulder.
HospitalizedMultiple body parts, n.e.c.Pickup truck
An employee was directing traffic when a shag truck turned sharply and ran over the employee. They suffered a crush injury to the lower left leg and internal bleeding.
An employee was standing on the street holding a stop/slow paddle and directing the flow of traffic. As they were holding the stop sign, a vehicle attempted to drive around the employee but struck them. The employee sustained fractures to the tibia and fibula and was hospitalized.
A paving crew was working on a roadway when a motor vehicle entered the work zone. Two employees sustained injuries including fractures and damage to internal organs that required hospitalization.
An employee was flagging traffic when they were struck from behind by a car that entered a work zone. The impact of the vehicle threw the employee approximately 45 feet and she landed on another employee. The employee who was struck by the car sustained a head laceration and fractures to the ribs and ankle.
An employee was setting up a worksite on a roadway when they were struck by a vehicle. The employee suffered blunt force trauma to the chest, pelvis, and legs from contact with the vehicle, with subsequent trauma to the neck and head upon falling to the ground.
More severe injuries in this industry (NAICS 238990)
A crew was relocating a dumpster (containing approximately 200 pounds of demolished wire) to access the uninterruptible power supply (UPS) units they were servicing. During movement of the dumpster, a section of carpet tile dislodged from the floor, causing an employee to lose his footing, slip, and fall. He landed on his right wrist, resulting in a fracture.
An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.
An employee was using an aluminum extension ladder to remove gutters at a height of approximately 20 feet. As they were removing the gutters, part of the gutter collapsed and struck the ladder, causing it to move sideways. The employee fell from the ladder and sustained fractures to ribs on the left side and their right forearm.
An employee was using an electric saw to cut a piece of wood for a fence. The saw slipped out of his hand and lacerated his left leg. He was hospitalized.
An employee was erecting a scaffold. A side bracket was not secure. The employee stepped on the bracket to test it and fell 18 feet to the concrete floor resulting in fractures to the ankles and femurs. He was not using fall protection equipment.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.