TNT Crust

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

A team was disassembling a dough pump s auger to allow the wastewater to drain from an allergen changeover. The auger became stuck due to suction caused by residual wet dough. A paddle was being used to pry the auger loose when the suction force suddenly released, causing the auger to retract unexpectedly. A finger on the employee's left hand was caught between the auger and the housing, leading to an amputation to that finger.

On February 4, 2025, at approximately 6:20 PM, an employee was cleaning the dough inside a divider when they sustained an amputation to their right index fingertip.

An employee was troubleshooting a mixer on the biscuit line when their hand became caught under the machine belt, resulting in fractures and an amputation of their middle fingertip. The machine was not locked out/tagged out at the time.

An employee was operating the bake sealer (used to seal the product) on the line and there a change over in the process. The employee was moving the bake sealer when he slipped and his hands were caught between the moving belts of it, resulting in a partial amputation of the left little finger.

An employee was attempting to stop tools from falling into product when their right hand was lacerated by the blades in the dough chunker machine.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.