Caught in running equipment or machinery during regular operation · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at INX International Ink Co., 3100 West Wisconsin Ave., APPLETON, WISCONSIN 54914
on — Fractures, affecting the forearm(s).
Final narrative
An employee was preparing material to add to a batch on a mixer. A plastic bag became tangled in a mixer shaft, and the employee's arm also became wrapped around the shaft. The employee suffered a compound fracture to the left arm.
HospitalizedForearm(s)Special process machinery, n.e.c.
An employee was adding chemicals to a mixer when a combustible dust explosion occurred and started a fire. The employee jumped off the platform, which resulted in broken bones; the employee was also burned.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 325910)
An employee was taking out the trash through the storeroom door when the storeroom door closed on their left index finger. The employee's fingertip was amputated.
An employee had been using a hoist to add bulk bags of pigment to tanks in an area that was not air conditioned. The employee collapsed from heat stress and was hospitalized due to dehydration.
An employee was pumping varnish from a holding tank into a tub for a production batch. He was filling the tub through a flex hose. When the hot varnish started flowing, it caused the flex hose to move and spray hot varnish. The employee sustained burns to their back requiring hospitalization.
An employee was adding chemicals to a mixer when a combustible dust explosion occurred and started a fire. The employee jumped off the platform, which resulted in broken bones; the employee was also burned.
An employee was moving drums off a skid. When he set a drum back down, his ring finger was caught between the rims of two drums resulting in amputation of the fingertip.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.