Fly Form Structures

An employee was pulling a showing frame off the top of a stack of showing frames. The frames were stacked 10 to 12 high and weighed 50 to 60 lbs. each. As he pulled and turned with the top showing frame, the stack fell over and struck his left hip. The employee sustained a fractured hip.

An employee was dismantling shoring equipment when his right ring finger was partially amputated.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

An employee was working on a 6-foot ladder that was leaned against a gas compression engine. The ladder feet slipped on the working surface, causing the ladder to become unstable. The employee fell off the ladder and suffered bilateral wrist fractures.

An employee was reinstalling an idler weighing approximately 400 lbs. on a bulldozer when the idler shifted slightly, pinching the employee's finger. The employee sustained an amputation.

An employee was filling a pressure washer with gasoline when the vapors ignited, resulting in the employee suffering burns to his face, hands, and arms.

An employee was preparing to unload freight from the liftgate of their truck while at a client location. They stepped into a pothole and fell onto their left side, resulting in a broken hip that required hospitalization and surgery.

An employee was using a torch to remove a broken bolt from inside a roller drum. Prior to this, brake cleaner had been used inside the roller drum. The employee was inside the roller drum when a flash fire occurred and the employee sustained burns to their face and arms.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.