Infinity Foods

On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.

An employee was examining a machine when a part moved up and amputated a fingertip on their left hand.

An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.

An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.

An employee's right hand was caught in a wire drawing machine, resulting in amputation.

Two forklift drivers were stopped next to each other and were talking. The injured employee leaned out of their forklift as the other forklift was leaving and they became pinned between the two forklifts. The injured employee was hospitalized with a fractured rib and a lacerated lung.

At about 3:30 p.m. on May 8, 2025, an employee slipped and fell backward while walking around equipment. He landed on the ground, near a water trench into which a steam line and a condensation return line were piped. Hot water from the trench burned his back between the shoulder blades.

An employee was troubleshooting a motor when their right little finger became pinched between the belt and pulley, resulting in amputation of the fingertip.

An employee was driving a forklift to a shipping dock. While he was rounding a corner, a stack of totes fell, and the top of one of the totes struck the outside of his left calf. He was hospitalized.

A crew was preparing a 20-foot section of 12-inch high-density polyethylene (HDPE) pipe to be swung into a welder using an excavator, where it would be welded onto a longer run of pipe. One employee was facing the longer pipe in the welder while the 20-foot section was being rigged. The 20-foot section moved and struck the employee's left knee. The employee's left leg was broken below the knee.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.