JDC Demolition Company

An employee was checking the function of newly installed actuators when they were struck by a pressurized release pipe. The employee suffered fractures to the orbital socket and shoulder, requiring hospitalization.

A ramp in the trunk of a delivery van struck an employee's calf. She suffered a broken leg and was hospitalized.

An employee was completing a service call and looking at a water pump when the pump cover plate struck their forehead. The employee sustained a forehead laceration and fracture requiring hospitalization.

An employee was removing chains from a steel tube. A sorting hook attachment was caught on the staging area cross member. When he raised the chains, the sorting hook snapped back and struck the employee's face causing a fractured jaw.

An employee was in the sawmill basement using a push broom and shovel to clean wood chips and sawdust. The employee's right arm was struck by a wooden board between the wrist and elbow, resulting in a fracture.

An employee was fixing a broken purlin at a worksite when they fell from the framing to the concrete floor approximately 19 feet below. The employee sustained brain bleeding and fractures to their face, vertebrae, and wrists.

Employees were removing scaffolding that was used to repair an ion exchange tank. The line was undergoing the regen process when a piece of scaffold struck a PVC pipe that transported hydrochloric acid (HCl). The injured employee was placing material inside a scaffold rack when he was sprayed in the face with HCl and sustained chemical burns to his eyes, face, chest, right arm, and left leg.

An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.

The injured employee was training a new employee on a dough machine. She went to show where the batter comes from and her right index fingertip was cut. The employee sustained an amputation to the fingertip. The machine was not guarded at the time of the incident.

An employee was operating a roller machine on a dirt slope when the machine hit a bump and fell onto it's side. While trying to get free of the falling machine, the employee's legs were pinned by the top bar of the cage. The employee was hospitalized and his left leg was amputated. He also sustained fractures to a hand and finger.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.