Other fall to lower level less than 6 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Heatcraft Refrigeration Products LLC , 420 Southwell Blvd., TIFTON, GEORGIA 31794
on — Fractures, affecting the hip(s).
Final narrative
An employee was stepping down from a 12-inch-tall foot stool when he fell and struck the ground, landing on and fracturing his left hip.
HospitalizedHip(s)Step ladders
More severe injuries at Heatcraft Refrigeration Products LLC
An employee was doing brazing work on a copper line, part of a commercial refrigeration unit that was charged with propane. A blockage in one of the tubes resulted in a flame blowback. The employee suffered second-degree burns to the left side of the face and neck area. They were hospitalized, requiring surgery.
An employee entered an interlocking gate to adjust a part when the gate malfunctioned and the brake press crushed his right arm up to the elbow. The employee was hospitalized and underwent surgery on his arm with multiple fractures. Later the employee underwent another surgery where his arm was amputated below the elbow due to complications.
An employee was drilling holes in copper tubing while wearing gloves. As she moved a part into position and began lowering the drill head, her right hand bumped the drill bit, which caught the fabric of the glove and pulled her right hand into the bit. The drill bit deeply lacerated her middle finger and partially amputated her pinky and index fingers.
An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.
An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.
An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.
An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.
An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.
More severe injuries in this industry (NAICS 333415)
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.
An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.
An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.