Injured by slipping or swinging object held by injured worker · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at M&M Coastal Manufacturing Inc., 8700 Hirsch Rd, HOUSTON, TEXAS 77016
on — Cuts, lacerations, affecting the thigh(s).
Final narrative
An employee was operating a power saw from his knees and was cutting a pallet to discard. The power saw kicked back and part of the blade cut the employee's right leg above the knee, causing a deep laceration. He was hospitalized for surgery.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 332311)
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.
An employee was moving and handling cardboard boxes when he sustained a laceration to his left ring finger from a box. The laceration became infected and required hospitalization and surgery.
An employee was positioning a piece of metal trim for a test bend in a single-fold bend machine. Their right middle fingertip was pinched by a clamp on the machine, resulting in a partial amputation.
An employee was operating a double folding machine and positioning a piece of metal trim in the folding clamps for a test bend. The machine activated and the crank (lower control arm that bends the trim) came up and cut through the employee s glove, amputating their right middle fingertip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.