Caught in running equipment or machinery during maintenance, cleaning · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Republic Services, Inc., 205 Lower River Road, COVINGTON, GEORGIA 30016
on — Soreness, pain, hurt-nonspecified injury, affecting the hand(s), unspecified.
Final narrative
While cleaning the blade on a waste truck, an employee's hand was caught and injured in the blade area, requiring hospitalization. The truck was running at the time of the incident.
HospitalizedHand(s), unspecifiedGarbage, recycling, or refuse truck
On January 15, 2024, an employee was operating a forklift carrying a 700-pound container. He was making a right turn into the facility when the forklift tipped over onto its left side, crushing the employee's left leg. The employee's left leg was amputated below the knee.
On September 13, 2022, an employee was disassembling shelves in the parts room when an upright shelf fell, hitting his head and causing a laceration near his right eye.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 562212)
A driver had backed up a rear load truck to a dumpster. The winch cable was bound, and another employee went to use the controls to put slack in the line. The cable tightened instead of loosening while the driver was holding it, and it caught his hand against the truck and crushed his thumb. The thumb was fractured and lacerated; he was hospitalized, requiring surgery. The incident took place during a training activity.
An employee was pulling into a customer's parking lot to pick up a roll-off container when the vehicle ran over the median curb. The vehicle then veered to the left, striking the side curb and the retaining wall. The employee sustained injuries to his neck and spine, as well as a damaged artery, a head laceration, and fractured ribs.
An employee was replacing the bracing arm of a baler. The replacement part (weighing an estimated 500 pounds) was moved into place using a truck-mounted crane with a lifting strap attached to the designated pick point. The employee then used his right hand to stabilize/align the part. The part shifted, crushing his right index finger against the mounting pin hole. The employee's finger was amputated above the first knuckle.
An employee was moving a mower with a tractor bucket when the bucket slipped and struck another employee on the hand. The injured employee sustained a partial amputation of their left little finger.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.