Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Genesee Global Group, Inc. , 975 John Street , WEST HENRIETTA, NEW YORK 14586
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was operating a Haeger Press and inserting a pem stud into a flat steel part. While his hands were between the tooling on the machine, the machine activated causing his left thumb to be caught between the top anvil and the steel part and amputating the tip.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333513)
An employee was using a foot-pedal-operated shear press. While the employee was adjusting material in the press, it activated and crushed their left ring fingertip, resulting in an amputation.
An employee was tightening a bolt on a brass plate located on top of a die when the ram block underneath the press contacted their right index finger, resulting in a partial amputation. The ram block was not locked out at the time of the incident.
An employee was loading a steel bar into a thread-rolling machine. The employee attempted to reposition the bar when it started spinning and caught his left glove. The employee's thumb was pulled into the feed table roller, resulting in fractures to the left thumb, wrist, and forearm.
A commercial jet aircraft crashed into the northwest corner of the facility and a fire resulted. An employee inside the facility sustained burns to his head, neck, and back.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.