Contact with hot objects or substances · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Wendbeck Corporation, 120 Harper Park Drive, BECKLEY, WEST VIRGINIA 25801
on — Second degree heat (thermal) burns, affecting the neck and back.
Final narrative
On January 24, 2017, at approximately 2:13 p.m., an employee was injured while operating a chicken pressure fryer. The lid to the cooker was closed, but did not latch. Approximately 5 minutes into the cooking cycle, the pressure inside the cooker caused the lid to open and grease, heated to 350 degrees, splattered on two employees. The first employee was hospitalized for second degree burns to her back and neck. The second employee was treated for first degree burns to his back and was released.
HospitalizedNeck and backFats, oils, cooking greases
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 722513)
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was kneeling on the ground while painting in a hotel area. He felt a prick, then overnight had a lot of pain, irritation, and some swelling. The employee was hospitalized with an infection in his knee.
A contractor was performing maintenance on a fryer when it tipped over, causing hot oil to splash onto the injured employee, who was nearby. The injured employee suffered burns that required hospitalization.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.