Fall on same level while climbing stairs, steps, or curbs · Major tears to muscles, tendons, ligaments
At a glance
Federal OSHA recorded a severe workplace injury
at Mid South Lumber, 1115 C Street, MERIDIAN, MISSISSIPPI 39302
on — Major tears to muscles, tendons, ligaments, affecting the shoulder(s), including clavicle(s), scapula(e).
Final narrative
On 2/8/17, an employee was walking upstairs with a chainsaw when the employee slipped on oil and fell, tearing the rotator cuff in the right shoulder.
HospitalizedShoulder(s), including clavicle(s), scapula(e)Stairs, steps, unspecified
A nurse was visiting the home of a patient for requested treatment. She tripped on her gown while going up the steps to the property, falling and fracturing her left femur.
An employee was walking up an escalator that was out of service when they tripped on a step, fell, and suffered a closed fracture to the right femur as well as a dislocated right patella.
More severe injuries in this industry (NAICS 321113)
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.