Tray-Pak Corporation

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was moving a stand-up powered industrial truck from a warehouse to a service area. During a turn on a slight decline, the vehicle's steering chain broke and the vehicle spun. The employee fell off the vehicle and landed on his right knee, breaking his fibula.

An employee had just driven a forklift onto a trailer and was stepping down from the forklift cab onto the trailer bed. He stepped onto a chain/buckle system (used to secure the forklift to the trailer bed during travel) and fell from the deck. He suffered a head laceration and two broken vertebrae and was hospitalized.

The injured employee was leaving to go to lunch when he and another employee tried going through the office door at the same time. The employees bumped into each other and the injured employee lost his balance and fell to the ground. He was hospitalized with a broken hip.

An employee was pushing mailers when the arm/knife of a picking counter machine caught their hand. The employee suffered the amputation of their right middle finger above the knuckle. The machine was not sufficiently guarded.

An employee was using a belt sanding machine to put a 45-degree angle on the end of a metal flat-bar (1"W x 24"L x 3/8"T). The flat bar was caught between the tool-rest and the belt, causing the opposite end of the flat bar that the employee was holding to spring back toward the machine. Their left hand struck the belt/machine guard resulting in amputation of 3/4 of their little finger. Their ring finger was also lacerated.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.