Greene Tweed and Company

An employee was operating a machine when a coworker tipped over a cart. A mold fell from the cart and struck the employee, breaking the employee's lower leg and foot.

An employee was adjusting a blade on a padder machine. As he manually turned a roller, his hand contacted the blade, amputating his right thumb tip.

An employee was cleaning a slicer when the tip of their right index finger was amputated, requiring hospitalization.

An employee was tying a feed bag when his hand slipped and struck the side of the feed hopper resulting in a laceration to the left wrist. The employee was hospitalized.

At approximately 9:45 AM, a maintenance technician was assisting in removing a feed roller from a coating tank. The bolts were removed and a supporting chain was in place. The technician was using a prybar to unseat the roller shaft when the prybar slipped, causing him to lunge forward and strike the right side of his face against a valve stem. The technician sustained a fracture and laceration to the cheek, and required surgery for an injury related to his right eye. He was hospitalized.

An employee was cleaning and performing maintenance on a vertical panel saw when the employee impacted the saw blade. They sustained a finger fracture and laceration.

An employee was working with fiberglass and resins. The employee was hospitalized after having difficulty breathing caused due to chemical exposure.

The injured employee was letting air out of a winding shaft using scissors as a lift table was used to pull the roll off the shaft. The roll/cardboard core slid over the top of the injured employee's scissors and caused the scissors to amputate the employee's little fingertip at the nail base.

An employee was dropping off a skid of laminate to be cut at a table saw. The skid was lifted and the forks tilted forward when the stack slid forward and struck the injured employee. The employee was pinned between the laminate and the table of the saw, resulting in a back fracture and a laceration to the liver.

An employee was using a machine to cut a roll of plastic sheeting. The employee's right hand was at the end of the roll, and when the cutting mechanism of the machine cycled, the employee's right middle and ring fingers were cut, resulting in amputations to both fingers.

An employee was running acrylic film through an automated winding machine which wraps film around a cardboard cylinder core. He noticed that the film had slipped off the winder. He went to the front of the machine to re-attach the film to the winder spool. His fingers got caught between the film and the spool and his left arm was pulled up by the winder spool. The employee was hospitalized with a broken left forearm. Another employee injured their shoulder when pulling the first injured employee out of the machine.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.