Green Valley Associates

An employee was unnesting tote bags when her grip slipped and the back of her left hand hit a box containing a steel step stool that was adjacent to the tote bags. The employee's hand was fractured.

An employee was cleaning up and putting away equipment when the second toe on her right foot was stubbed on a fixture, resulting in hospitalization and a subsequent amputation of the toe.

An employee was walking when he tripped on a concrete vault lid, jamming his big toe into the tip of his steel toe boots. The employee's big toe was medically amputated.

An employee was cleaning a bathroom. As the employee bent over, the corner of a sink hit the employee's right eyeball, causing an injury that required hospitalization and surgery.

On September 23, 2023, an employee was cleaning near a conveyor when they knelt with their right knee on the floor. Their knee contacted a small piece of glass on the floor, resulting in a laceration that required hospitalization.

An employee was pushing an oxygen concentrator when she tripped over the base of a whirlpool chair. She fell onto her left hip and broke it.

An employee was working on a hitch, using a hydraulic vise to hold it in place. His left index finger was caught between the vise and the hitch, and his fingertip was crushed. The fingertip was medically amputated at the first knuckle.

An employee was transporting a resident in his care in a work van when he was assaulted by the resident. The employee was hospitalized with a broken neck and an inability to swallow.

During maintenance work on an exterior fan, wind gusts caused the fan to rotate. The fan pulley system amputated two of an employee's fingers.

An employee had just completed his building check during a security round and was walking down the steps to the sidewalk. As the employee stepped onto the sidewalk, he slipped on ice and fell, resulting in a concussion and bruising of the cervical spine. The employee was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.