Georgia-Pacific Corp

The high density clean out drain knife gate valve was stuck in the open position. When the employee attempted to confirm the knife gate valve was closed, by feel, the knife gate valve closed on the employee's fingers causing the amputation of three fingertips on the right hand.

While attempting to investigate the cause of a hot wood pulp stock overflow, an employee stepped into pulp stock that was higher than his rubber boots. The stock was approximately 135 degrees and caused second degree burns to the employee's right leg and foot, requiring hospitalization.

An employee was stepping out of a car when they slipped and fell on ice, resulting in a femur fracture.

An employee was closing up for the weekend when they slipped on oil and brake fluid and fell. The employee suffered a leg fracture.

An employee was working in the forest flagging an area to be harvested. He took a step and his foot slipped on a stick hidden under the leaves, causing him to fall to the ground. He landed on his right foot/lower leg resulting in a fractured tibia.

An employee was inspecting an apartment to ensure it was ready for a new resident to move in. The carpet in the apartment had been recently cleaned and was still wet. As the employee went from the carpet to the tiled floor of the bathroom, they slipped and fell, resulting in a torn left hamstring.

An employee was delivering a letter along a rural carrier route when she stepped on an ice-covered snow drift, slipped, and fell to the ground. The employee sustained a right hip fracture that required surgery.

An employee was clearing a material jam on a line, at a point where it formed the cores of diapers. When he removed the material, his left little finger was caught between the belts of a forming drum. His hand was lacerated and the finger was broken. He was hospitalized, requiring surgery. The machine was guarded at the time of the incident.

An employee slipped on a recently mopped concrete floor and fell. The employee sustained a hip fracture.

On April 9, 2025, an employee was cleaning anilox rollers in a machine with a rag. The machine caught the rag and then the employee's left hand, resulting in amputation of the middle finger.

An employee was jogging two rollers to clear a paper jam when his left hand was pulled into the rollers, resulting in amputations of the index, middle, and ring fingers down to the knuckle.

On July 27, 2024, at 2:45 AM, an employee was walking down an aisle in the converting department when he tripped and fell on the ground. The employee was hospitalized with a fractured left hip.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.