Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at KCS International Inc., 205 Charles St., OCONTO, WISCONSIN 54153
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was cutting metal pieces in a shear that is operated with a foot control. While he was leaning forward to adjust a piece with his hand, his foot pushed down on the foot control and activated the shear, which then amputated his right middle fingertip.
An employee was walking across a parking lot with his hand tools. The lot had been plowed and salted but patchy snow/ice was present. He slipped on the snow/ice and fell, fracturing his ankle and requiring surgery.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 336612)
An employee was unbinding material that was caught in a horizontal band saw. The became unbound and it re-engaged while the employee was reaching for the blade. Two of the employee's fingers were amputated.
An employee was working in the hull of a boat, applying resin as part of lamination activities. He sat down and lost consciousness due to heat exhaustion. The employee was hospitalized.
An employee was operating a surfacing machine that used a rotating wire brush in a cabinet. A sheet of EVA foam material became stuck in the machine; as the employee was removing it, the wire brush contacted his left hand. He suffered a fracture and abrasions to the left arm.
An employee was operating a CNC machine. The employee lifted the guard and went to clean a part. The tooling was still rotating and caught the employee's glove, pulling it into the tooling and amputating their left ring finger.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.