American Bin & Conveyor LLC

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

An employee was preparing to remove the drive chain of a conveyor motor. Their thumb became caught in the sprocket and chain of the drive motor, resulting in an amputation to the thumb tip between the nail and the first joint.

An employee was working with a drill press when his glove and forearm were caught by the drill bit, resulting in lacerations and fractures to his right forearm. The employee's arm was amputated below the elbow.

An employee was walking on a sidewalk when he stepped off the sidewalk into the grass. As he was stepping onto the concrete parking lot, he tripped over the edge of the concrete and fell onto his left hip. The employee was hospitalized.

An employee was changing the cooling nozzles on an aftercooler and the pneumatic power was activated. This caused the top plate to move into the top position and crush the employee's right arm. The employee sustained a fractured arm.

On October 15, 2024, an employee was cleaning a drum welder with a rag. The machine pulled in the rag and injured three fingers on the employee's left hand. The employee was hospitalized with three partially amputated fingers.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.