Injured by slipping or swinging object held by injured worker · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Railworks Track Systems, 5605 TX-332, CLUTE, TEXAS 77531
on — Soreness, pain, hurt-nonspecified injury, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was attempting to reinstall the connecting bar for a pressure-actuated rail greaser. He was picking up the bar from the middle joint when the joint unexpectedly straightened and injured his finger.
HospitalizedFinger(s), fingernail(s), unspecifiedMachine and appliance parts, n.e.c.
A crew was lifting a bridge with bottle jacks so they could remove and replace floor-to-ceiling joists. Soil at one end gave way, causing a wall of lumber to collapse on the foreman who was observing them. The foreman suffered fractured vertebrae.
An employee was installing a railroad bumping post. As he loosened a nut on a bolt so the bolt could be re-seated, the bumping post collapsed and his right leg was pinned between two pieces of it. He suffered fractures to the tibia and fibula.
An employee was using a spike maul to set a steel spike in a wooden tie. The spike maul struck the steel joint bar and the impact broke a small piece of steel off the joint bar. The small piece of steel struck the employee in the right eye.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 238990)
A crew was relocating a dumpster (containing approximately 200 pounds of demolished wire) to access the uninterruptible power supply (UPS) units they were servicing. During movement of the dumpster, a section of carpet tile dislodged from the floor, causing an employee to lose his footing, slip, and fall. He landed on his right wrist, resulting in a fracture.
An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.
An employee was using an aluminum extension ladder to remove gutters at a height of approximately 20 feet. As they were removing the gutters, part of the gutter collapsed and struck the ladder, causing it to move sideways. The employee fell from the ladder and sustained fractures to ribs on the left side and their right forearm.
An employee was using an electric saw to cut a piece of wood for a fence. The saw slipped out of his hand and lacerated his left leg. He was hospitalized.
An employee was erecting a scaffold. A side bracket was not secure. The employee stepped on the bracket to test it and fell 18 feet to the concrete floor resulting in fractures to the ankles and femurs. He was not using fall protection equipment.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.