John Deere Commercial Products

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

During a break, an employee was engaged in a conversation with a customer. They were standing approximately 7 feet in front of a combine header that was attached to a payloader but also set on jack stands for support. The header dislodged from the payloader, slid forward along with its support stand, and struck both the employee and the customer. The employee was hospitalized with fractures to thoracic and lumbar vertebrae, a fractured rib, and a partially deflated lung. The customer also sustained injury.

An employee was replacing a manure belt in an egg producing poultry house. He was using a mechanical roller and a steel cable to pull (remove) the old manure belt. The employee's ring and little fingertips were pinched between the roller and the cable resulting in partial amputations above the top knuckle.

An employee was walking past a cow barn when he slipped on a wet floor mat and fell. The employee sustained torn ligaments and his quadriceps were torn from the bone on both legs.

An employee was working on a bale accumulator attached to a tractor. While he was making adjustments, the accumulator activated. The bar of the accumulator struck him and dragged him to the side, and his right leg was run over. He suffered a broken femur.

An employee tripped on a piece of wood and fell onto the rough edge of a metal tank under fabrication. The employee was hospitalized with a laceration on his hand.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.