Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Waterman Log Crafters LLC, 10785 Commerical Avenue, WISCONSIN DELLS, WISCONSIN 53965
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee used a push-stick in his right hand to push a piece of soft wood through a wood jointer to remove a 1/8 inch of wood from the board. He was using his left hand to guide the board through the jointer when his left-hand fingers came in contact with the jointer blade. The jointer blade completely amputated four fingers and partially amputated another finger. The jointer was guarded at the time.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
On April 17, 2025, at 3:20 p.m., an employee was cleaning a drawer machine by blowing down the machine with air. His left hand was struck by the rotary blade on the machine, resulting in amputation to the index fingertip. The machine was guarded at the time.
An employee was unclogging the sawdust collection system on a gang saw when they sustained amputations to their left middle fingertip and right index fingertip from the spinning turbines in the chute.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.