BALDOR ELECTRIC COMPANY

An employee fell out of a rolling office chair onto a cement floor breaking his hip and lacerating his head.

An employee's left small finger was amputated while operating an overhead hoist. The equipment was not locked or tagged out and was unguarded at the time.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee was cleaning a machine and bleeding its lines. After the gauge read 0, the employee removed the metal lid covering a filter. The lid popped off and struck the employee in the face, causing a broken nose, a broken jaw, and lacerations.

An employee was burned by an arc flash that occurred in an electrical room.

An employee was carrying a metal plate (18 inches x 18.75 inches) when it dropped onto his right foot, resulting in a fracture.

An employee was troubleshooting a variable frequency drive (VFD). There was an electrical discharge. The employee experienced an electrical shock of approximately 480 volts and sustained second- and third-degree burns on their right hand, wrist, forearm, and elbow.

An employee was operating a press and sustained broken bones in the right hand.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.