Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Lamons Gasket, 7300 Airport Blvd, HOUSTON, TEXAS 77061
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using a small bending machine to bend a stainless 1/4 inch wide by 8 feet long metal rod into a circle. He was routing the material into the rollers when his fingers were caught in the rollers, resulting in a right middle finger amputation, first index (nail section).
A temporary employee was using a large bending machine to bend a 3/4-inch by 8-foot piece of metal. As he guided the piece through the rollers on the machine, his fingers were caught in the rollers and his left little finger was amputated.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 339991)
An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.
An employee was performing stamping operations using a 160-ton press machine. They began to clean the machine when the press came down on their hand, resulting in multiple finger amputations.
An employee was feeding a ring into a horizontal winder when the ring got caught. As the employee was getting it to continue feeding into the machine, her right middle finger was caught in a pinch point on the machine's wheel. The fingertip was partially amputated.
An employee was operating a tape cutting machine, which automatically cuts 2-inch cloth material into predetermined lengths. The material became jammed in the blade, which froze in the partway down position. The employee began working to unjam the material. The machine activated, causing the blade to become free. The blade came down and amputated the employee's left index fingertip above the first knuckle and the tip of their left thumb.
An employee was adjusting a ring on a bar bending machine when their glove became caught in a pinch point on the machine. The machine was activated and the employee sustained fractures to the four fingers on their right hand and amputations to the index and little fingers.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.