Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Winston Plywood & Veneer, LLC, 1160 S. Church Avenue, LOUISVILLE, MISSISSIPPI 39339
on — Amputations, affecting the hand(s), n.e.c..
Final narrative
An employee was removing wood from a conveyor when the employee's left arm was caught between the wood and conveyor frame. The employee's left hand was amputated just above the wrist.
An employee was removing a piece of wood from the off end of a wood dryer. The employee's right hand was caught in the dryer's chain and sprocket; four fingertips were amputated.
An employee was inspecting a vault when a water hose popped out of the top of the vault. The 180-degree water caused first- and second-degree burns to his torso.
An employee removed a folded piece of veneer from a conveyor belt and then turned around to get ready to straighten the next piece. When he turned, his gloved left hand contacted the belt, which then pulled his index finger into the pinch point between the drive roll and guide plate. When he pulled his hand free, his index fingertip was torn off.
On September 11, 2017, an employee was reinstalling a carriage in a lathe that cuts logs into veneer when a manual chain hoist that was stabilizing the pressure roll slipped. His right arm was then pinched between the top and bottom of the lathe.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321212)
An employee was working to dislodge a piece of stray veneer from a conveyor. The employee set up a ladder against the machine and climbed the ladder. He placed his left hand on the rail of the conveyor and his fingers were caught in the chain and sprocket assembly that powers the conveyor. Three fingers were amputated. The machine was guarded at the time.
A maintenance employee was changing a shaft on a piece of equipment that had been isolated for repair. While positioning the shaft into place, the shaft fell approximately two feet and pinched the employee's left index finger. The employee suffered a partial amputation of the fingertip without bone loss.
An employee was using a cart to move saw blades. The cart tipped over, striking and pinning the employee under the blades. The employee sustained severe lacerations to their torso and legs that required surgery.
An employee was labeling and writing on the back of a slab of quartz. The material was leaned toward him when the A-frame it was resting on shifted, causing the material to fall onto his right leg and break it.
An employee performed maintenance on various machines when they began to feel hot and unwell, and they experienced cramping. The employee was hospitalized with heat stress or dehydration.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.