Caught in running equipment or machinery during regular operation · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at The Ziegenfelder Company, 87 18th Street, WHEELING, WEST VIRGINIA 26003
on — Cuts, lacerations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
On January 16, 2018, at approximately 5:00 a.m., an employee was operating a crimper machine when his finger contacted a pinch point and was severely cut, requiring hospitalization. The machine was unguarded at the time.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 311520)
An employee was using an end mill to mill out a section of a metal door frame that he was fabricating. Metal shavings built up and he could not see the marking to cut, so he used a small brush to remove the shavings. While brushing off the shavings, his glove became caught in the spinning mill bit and pulled his hand in. The employee's right index finger contacted the spinning bit, resulting in a partial amputation to the side of the finger.
An employee was unjamming cookie dough from a machine when the rotating pump caught her left index and ring fingers, resulting in fingertip amputations.
An employee was marking a malfunctioning mold when their finger got caught between one section of rollers on the mold and the guarding on the next section of rollers. The employee's finger was amputated below the nailbed.
An employee was exiting the rear door of a freezer truck when he slipped/misstepped and fell to the ground. The employee sustained a broken right leg that required surgery.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.