Schulze and Burch Biscuits

An employee was stepping out of a car when they slipped and fell on ice, resulting in a femur fracture.

An employee was closing up for the weekend when they slipped on oil and brake fluid and fell. The employee suffered a leg fracture.

An employee was working in the forest flagging an area to be harvested. He took a step and his foot slipped on a stick hidden under the leaves, causing him to fall to the ground. He landed on his right foot/lower leg resulting in a fractured tibia.

An employee was inspecting an apartment to ensure it was ready for a new resident to move in. The carpet in the apartment had been recently cleaned and was still wet. As the employee went from the carpet to the tiled floor of the bathroom, they slipped and fell, resulting in a torn left hamstring.

An employee was delivering a letter along a rural carrier route when she stepped on an ice-covered snow drift, slipped, and fell to the ground. The employee sustained a right hip fracture that required surgery.

An employee was using an end mill to mill out a section of a metal door frame that he was fabricating. Metal shavings built up and he could not see the marking to cut, so he used a small brush to remove the shavings. While brushing off the shavings, his glove became caught in the spinning mill bit and pulled his hand in. The employee's right index finger contacted the spinning bit, resulting in a partial amputation to the side of the finger.

An employee was unjamming cookie dough from a machine when the rotating pump caught her left index and ring fingers, resulting in fingertip amputations.

An employee was marking a malfunctioning mold when their finger got caught between one section of rollers on the mold and the guarding on the next section of rollers. The employee's finger was amputated below the nailbed.

An employee was exiting the rear door of a freezer truck when he slipped/misstepped and fell to the ground. The employee sustained a broken right leg that required surgery.

An employee was palletizing ice cream when his fingers got caught in a chain and sprocket, resulting in amputations of the middle and ring fingers.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.