ITW Shakeproof Industrial Products

Two employees were setting up a multi-die header machine. The machine was turned on while one of the employees was adjusting a bolt inside it. The employee's right middle finger tip was crushed between the bolt and the machine's oscillator and had to be amputated. The incident took place during a training activity.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was drawing wire when a chain caught three fingers on his right hand. The employee sustained an amputation to the right ring finger, the fingerprint pad of the middle finger, and the tip of the index fingerprint pad.

An employee was buffing production parts and the rotating wheel contacted their left hand, resulting in hospitalization due to a laceration to the hand and a fracture to the hand and wrist.

An employee was repositioning a washer on an assembly machine when the machine cycled and the employee's right index fingertip was caught and amputated.

An employee was operating a thread feeder when it caught her right index finger. The employee was hospitalized for injury to her finger.

An employee was helping to remove a die from a press. The forks shifted on the forklift they were using and the die pinched their arm against the safety bar, resulting in crush injuries to the right hand, a fractured right radius, and a laceration requiring stitches.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.