Contact with hot objects or substances · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Filmtech Corporation, 2121 31st Street SW, ALLENTOWN, PENNSYLVANIA 18103
on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
A mechanic was opening the slide gate of a plastic extruder machine when the heat zone element overheated the plastic up to 900 degrees instead of 400 degrees. The hot plastic sprayed out and onto a different employee who was approximately 10 feet away. The injured employee suffered burns to the arms and face.
HospitalizedMultiple body parts, n.e.c.Plastics, resins, n.e.c.
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 326112)
An employee was using straps to secure a load inside a transport trailer. The employee was standing on a stack of finished goods that was three pallets high. Each pallet was 16 inches high. He was walking from the stack of three pallets onto a stack of two pallets when he lost his balance and fell onto another stack of finished goods (that was two pallets high) and then landed on the floor of the trailer. The employee was hospitalized with fractured ribs.
An employee was unclogging a resin sifting machine. The rotary sifter's automatic system activated and the sifter blade struck the employee's fingertip, causing an avulsion. The fingertip was medically amputated.
An employee was helping to remove a roll of plastic from a line when the tail stock on the machine snapped back and caught the employee's right middle fingertip, resulting in a partial amputation.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.