Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Park Falls Hardwoods, 143 N 5th Ave, PARK FALLS, WISCONSIN 54552
on — Amputations, affecting the toes(s), toenail(s).
Final narrative
On June 13, 2018, an employee was clearing debris away from the photoelectric eyes on a conveyor that housed a kicker that moved logs. The machine engaged when the debris was moved which caused the kicker to cycle. The employee's right foot was crushed by the kicker resulting in the partial surgical amputation of two toes.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333210)
An employee was cleaning around a circular saw that was equipped with a chainsaw attachment when their right pantleg became caught in the saw attachment. The employee sustained a laceration to their lower leg that required surgery.
An employee was clearing a jam on a trim saw. A piece of wood had gotten stuck under the conveyor belt. The saw blades were off but the conveyor belt was running. The employee's right hand was near a chain that caught his glove and amputated his right ring and middle fingers and the tip of his little finger. A guard was in place at the time.
An employee was sitting by a heater when a nearby hydraulic line ruptured, spraying her and the heater with hydraulic fluid. The fluid on the heater ignited, which subsequently caused the fluid on the employee to ignite. The employee suffered burns to her shoulder and hands.
An employee was working on a piece of welded equipment. Having been lifted on one side by a crane, the equipment was being supported by the crane on one side and by a horse and braces on the other. While the employee was under the equipment adjusting the horse, the equipment shifted; the horse struck and injured the employee.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.