Oshkosh Coil Spring, Inc.

On 04-07-16, an employee was adjusting/operating a coil machine when two looping blocks came together and pinched the employee's finger, amputating the left index fingertip.

On May 8, 2015, an employee was putting an additional bend into a double torsion spring at a large servio table (wire bender) machine. He put his left hand on top of the part, and his left finger got caught between the bending mechanism (steel block) and the stationary block. He suffered a left ring finger amputation.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was retrieving a part. A nearby machine activated and amputated the tip of the employee's middle finger, as well as crushing the employee's index and ring fingers.

An employee was approaching the exit end of an automated and fully enclosed shot machine. A spring that was discharging jammed between the discharge pusher and the discharge transfer plate. The spring unjammed suddenly. Due to the excess force created between the discharge pusher and the discharge transfer plate, the spring shot out of the machine to the stop plate, a distance of approximately 8 feet. At that exact moment, the employee's hand was near the discharge table and the spring struck the employee's right arm, catching it between the spring and the stop plate. The employee suffered broken bones to the lower right arm (wrist area) as well as severed tendons and nerves.

On March 27, 2018, an employee was operating a mandrel machine when it amputated the employee's right hand/arm.

While placing springs into a grinding machine, an employee contacted the guide edge of the grinding machine, amputating the right index fingertip. The machine was unguarded at the time of the incident.

An employee was troubleshooting a press machine. The machine completed its cycle while the employee's hand was next to an air cylinder, partially amputating the employee's left middle finger and fracturing the left ring finger.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.